Skip to main content

BREW GUIDE - ESPRESSO

 

Brewing consistently great espresso coffee can be very difficult but we hope that this simple guide will help you to get the best out of our espresso coffee at home.


We recommend keeping a consistent dose of coffee based on the size of the filter basket used. This is usually 18-20 grams of finely ground coffee. Decide how much espresso coffee you want to extract into the cup depending on the desired strength.

Here 1:2 is a good starting ratio, 40 grams of brewed espresso to 20 grams of coffee grounds. The grind size can then be adjusted to reach the desired level of extraction.



A good espresso usually takes around 26-32 seconds to brew so this can be used as a benchmark.

A finer grind will result in a longer brew time and a higher extraction whilst a coarser grind results in a shorter brew time and a lower level of extraction (ensuring you have an even puck-prep technique). If the level of extraction is too low then the finished espresso will taste sour and lack sweetness. An espresso ground too fine will taste bitter or astringent and lack sweetness.

The art of brewing espresso is finding the perfect balance between each of these parameters in order to brew a sweet and balanced beverage.

Serving - 40ml or 1-2 cups

Equipment:
Espresso machine
Espresso grinder
Tamper
Freshly roasted espresso beans
Digital scale

Dose: 18 - 20 grams
Grind: Fine
Water: 96 degrees
Brew Time: 28-30 seconds

It’s important to always start with a clean and well-serviced machine for the optimal taste experience.

 

Step 1

Remove the portafilter from the machine and wipe it clean with a clean rag. Place the filter on a digital scale and tare the weight.



Step 2

Purge the espresso group head thoroughly to rinse it off any old coffee grounds.



Step 3

Grind 18-20 grams of coffee into the portafilter depending on the size of the filter basket and distribute the coffee grounds evenly in the filter using the side of a finger or a distribution tool. An even coffee bed is paramount for an evenly extracted, and therefore balanced, espresso.


Step 4
Place the portafilter on an even surface such as the edge of a countertop and press down evenly with a tamper. Adequate pressure is required to create an even seal but you need not apply excessive force. Give the tamper a little spin to remove loose particles from the surface before removing it. Do NOT tap the portafilter and be careful from now on as the slightest tap can cause tiny channels to form in the puck, causing water to bypass the grounds and creating an astringent espresso (this is what we call channelling).



Step 5
Carefully secure the portafilter into the espresso machine and immediately begin the brewing process. Brew into a preheated espresso cup (or two cups if brewing two single espressos) using a digital scale to record the weight of the final beverage.



Step 6

Aim to brew a 1:2 ratio in around 30 seconds before adjusting the recipe to achieve a balanced espresso. The shot should begin with a slow drip after a few seconds before opening up into more a steady flow. Using a bottomless portafilter is a good way to see the espresso shot develop and gain a greater understanding of how evenly your espresso extracts.

Step 7

Some prefer to give the espresso a gentle stir before tasting whilst others recommend against this. Enjoy your freshly brewed cup of Lykke coffee neat or with expertly foamed milk, whichever way you may prefer. 

BREW GUIDES

BREW GUIDE | Cupping with Lykke

BREW GUIDE | Cupping with Lykke

Feb 09, 2024 Lasse Hartikainen

Coffee cupping, the age-old practice of evaluating and appreciating the flavours, aroma, and nuances of coffee, is an essential technique used by professionals and enthusiasts alike.

More reading:

thumb-recipes.jpg__PID:a249c82d-6e91-4958-b45a-e5f90b35526d
thumb-stories.jpg__PID:b15a9aaa-8b7a-4f2c-a37c-8a7631b54122
thumb-farms.jpg__PID:09ea769b-7da7-4251-8d81-4c64a01d45a8

Your Cart

Your cart is currently empty.
Click here to continue shopping.